Herunterladen Inhalt Inhalt Diese Seite drucken

Bedienung; Operation - geo-FENNEL Multi-Liner FL 50 Plus Bedienungsanleitung

Vollautomatischer linienlaser
Inhaltsverzeichnis

Werbung

B EDIENUNG
G erät aufstellen:
1) A uf Stativ: Das Gerät kann direkt mit der
5 /8"-Stativanzugsschraube eines handelsüb-
l ichen Baustativs verbunden werden. FL 50
P lus kann auch mit montiertem Bodenstativ
a uf ein Baustativ geschraubt werden. Dazu
A dapterstück (11) unten in das Bodenstativ
e inschrauben.
2) A uf dem Fußboden: Bodenstativ (5) unten
i n das Gerät hinein schrauben. Beine aus-
k lappen. Gegebenenfalls mit höhenverstell-
b aren Füßen (13) Dosenlibelle im Kopf des
G erätes einspielen.
D urch Lösen „UNLOCK" der Klemme (12)
k ann das Gerät über einem definierten Bo-
d enpunkt ausgerichtet werden. Dann Klem-
m e wieder feststellen „LOCK".
G erät immer möglichst gerade aufstellen, da-
m it d ie Selbstnivellierung des Gerätes ein-
w andfrei arbeitet.
A nschalten: An-/Aus-Schalter (6) in Position
„ UNLOCK" stellen. Das Gerät ist nun betriebs-
b ereit.
S teht das Gerät zu schräg (außerhalb des
S elbstnivellierbereiches) von ± 3,5°, ertönt
e in akustisches Warnsignal. Eingeschaltete
L aserlinen blinken als zusätzliche Warnung.
A lle Laserlinien können einzeln geschaltet
w erden:
O PERATION
S et up the laser:
1) O n a tripod: Connect FL 50 Plus with 5/8"-
r etaining bolt of builders' tripod.
2) O n the floor: Screw in floor tripod (5) into
b ottom thread of instrument. Unfold three
l egs. If necessary center circular bubble in
h ead of instrument by means of height ad-
j ustable footscrews (13).
L aser plumb can be adjusted: set lever of
l ocking device (12) in position „UNLOCK" -
m ove instrument on floor tripod to desired
p oint - fix by moving lever to position
„ LOCK".
S et up instrument as upright as possible to
a llow the self-levelling system to function
w ithin range.
S witch on: Set On/Off knob (6) in position
„ UNLOCK". Instrument is now ready for use.
A n audible and optical alarm (blinking lines)
i ndicates the instrument was set up outside
o f compensator rage of ± 3,5 °. Set up
i nstrument on a more even surface.
A ll laser lines can be switched on and off
i ndependently of each other:
4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis