General Maintenance; Replacing The Cutting Blade - Ryobi RLM4614SME Übersetzung Der Originalanleitung

WARNING
If the machine is not maintained correctly then life span
of the tool may be reduced, and inbuilt safety features
may not function correctly, thus increasing the potential
for serious injury. Keep the product in good working
condition.
WARNING
Before performing any maintenance, stop the mower,
allow the blade to come to a complete stop, and
disconnect the spark plug wire from the spark plug.
Failure to heed this warning could result in serious
personal injury.
WARNING
When servicing, use only authorised replacement parts.
Use of any other parts may create a hazard or cause
product damage.

GENERAL MAINTENANCE

You may make adjustments and repairs described here.
For other repairs, contact the authorised service agent.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
Periodically check all nuts and bolts for proper tightness
to ensure safe operation of the mower.
Remove any buildup of grass and leaves on or around
the engine and engine cover. Wipe the mower clean
with a dry cloth occasionally. Do not use water.
Check the grass catcher frequently for wear or
deterioration.
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
CLEANING THE UNDERSIDE OF THE MOWER DECK
1. Raise the mower to full height.
Connect a female water hose connector (not supplied)
to the male hose connector on the mower deck.
3. Turn on the water supply.
4. Start the mower and run at full revolutions, but do not
engage the self-propel bail.
5. Run the engine in place for approximately 30 seconds.
6. Shut off the engine.
7. Turn off the water supply.
8. Inspect the underside of the mower deck for cleanliness,
and repeat the cleaning procedure if desired.
LUBRICATION
All of the bearings in this product are lubricated with
the unit under normal operating conditions. Therefore, no
further bearing lubrication is required.
WARNING
wrapping the cutting edges of the blade with rags and
other material when performing blade maintenance.
Contact with the blade could result in serious personal
injury.

REPLACING THE CUTTING BLADE

Be careful during adjustment of machine to prevent
parts of machine.
For best results, the mower blade must be kept sharp.
Replace a bent or damaged blade immediately.
WARNING
Only use replacement blades approved by the
manufacturer of your mower. Using a blade not approved
by the manufacturer of your mower is hazardous and
could result in serious injury, damage your mower, and
void your warranty.
WARNING
blade.
1. Stop the engine and disconnect the spark plug wire.
Allow blade to come to a complete stop.
Turn the mower on its side (carburetor facing up).
3. Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
4.
the blade bolt by turning the bolt in a counterclockwise
direction as viewed from the bottom of the mower.
5.
blade.
6. Place the new blade on the shaft. Make sure it is
installed with the curved ends pointing up toward the
mower deck and not down toward the ground.
7.
on the shaft. Finger tighten the bolt by turning in a
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG