Fronius Smart Meter; Integrating The Fronius Smart Meter; Meter Position; How To Connect The Smart Meter To The Datamanager - Fronius Ohmpilot Bedienungsanleitung

Fronius Smart Meter

Integrating the A Fronius Smart Meter is required to operate the Ohmpilot so that the surplus energy can
Fronius Smart
be measured. An inverter with Datamanager 2.0 or higher from V3.8.1-x onwards or a Da-
Meter
tamanager Box from V3.8.1-x onwards is required to integrate the Fronius Smart Meter.
On the Datamanager, it must be set whether the Fronius Smart Meter is installed at the
feed-in point or in the consumption branch. The setting must be made on the website under
the "Meter" tab for the Datamanager.
Further information on the Datamanager can be found in the "Fronius Datamanager 2.0"
Operating Instructions.

Meter position

(1a) Meter position at feed-in point. The power and energy fed in are measured. Consump-
tion is determined on the basis of these values and the system data.
(1b) Meter position in consumption branch. The power and energy consumed are meas-
ured directly. These values and the system data are used to determine the amount of pow-
er and energy fed in.
How to connect
the Smart Meter
to the Dataman-
ager 2.0
76