Installation - Honeywell Miller MightEvac Bedienungsanleitung

5.0 Installation

The MightEvac Self-Retracting Lifeline must be
mounted to an overhead anchorage by the attachment
swivel using a locking carabiner or other Miller approved
anchorage connector, or it must be used in conjunction
with a Miller mounting bracket which is then installed on
a tripod. The anchorage must be capable of supporting
a 5,000 lb. (22.2kN) tensile load. Review all warnings
and instructions when selecting a mounting location.
5.2 Installation of MightEvac
Step 1: Remove red, round protective stickers from both sides of the MightEvac unit.
Step 2: Insert attachment swivel of the unit into bracket as shown.
Step 3: Slide the unit forward until the threaded holes in the housing (where stickers were removed)
are aligned with the holes in the front of the bracket as shown.
NOTE: The carrying handle of the unit must be in the upward position away from the bracket.
Insert the fastener through the
lockwasher, spacer and hole in the
bracket. Tighten to 8 plus or minus
one (1) ft.-lbs. (96 plus or minus 12
in.-lbs.). Repeat for opposite side.
Step 4: Insert the pushpin through the
bracket in the holes provided. This
securely attaches the unit to the
bracket. Ensure the pushpin is
securely through both holes and
remains in place.
Step 5: Attach the unit with bracket to an
approved Miller anchoring device
and secure with the pushpins
provided. Refer to installation
procedures in sections 5.3, 5.4, 5.5, 5.6 and 5.7 of this manual.
To remove the unit, simply reverse the above procedures.
For general fall protection, connect the lifeline
end connector (i.e., snap hook) to the back
D-ring on the full-body harness.
MIGHTEVAC
WITH MOUNTING BRACKET
ANCHORAGE
CONNECTOR
(Ref. Fig. 1)
Fig. 1
12
ANCHORAGE
LOCKING
CARABINER
ATTACHMENT
SWIVEL
®
T. NO. 5,771,993
SEL F-RET RAC TING LIFELI NE WI TH EME RGE NC Y RE SCUE
WARNING! FAILURE TO OBSERVE INSTRUCTIONS
MAY RESULT IN SERIOUS OR FA TA L INJURY
• Always use and in spect unit in accordance • Do not allow the lifeline to become slac k.
with manufactu rer' s instructions.
• Do not allow ca ble, rope or webbing
• Do not use as a restraint or positionin g lifelines to com e in contact with anythin g
device. that will damage th e lifeline including, but
• Use only with att achment fittings and safety not limited t o, sharp, abrasive, rough or
harness recommended by manufacture r. high-tempera ture surfaces, welding, he at
• Always connect the hook directly to sources, electrical h azards, or moving
attachment point on harness. machinery.
• Guard against swing falls by keeping the • Wear gloves when inspecting or han dling
lifeline vertically ov erhead. Never work cable lifelines.
above the device. • Check lifeline fo r damage, frays, or cuts that
• Keep user and oth er workers from becomin g will reduce the streng th.
entangled in life line. • Maintain tens ion on the lifeline while letting
• Do not allow life line to drag over it retract after d isconnecting from wo rker.
obstructions. • Servicing must on ly be performed by the
• Never clamp off or s tand on the lifeline. manufacture r or an approved agent.
WARNI NG: Ma nufacturer 's instru ctions supplied with t his pro duct at t ime of shipme nt must be foll owed: Failure t o do so could resul t in seriou s
injury o r death. Only for use by ONE person as a pers onal fall arrester. Device m ust b e taken out of servic e for ins pectio n and recertif ication
after arres ting a fa ll or when the imp act indicat or h as been ac tivated. Contact Miller Fall Protec tion if in struc tion manu al is ne eded.
ADVE RTENC IA: Deb en seguir se los instrucc iones del fabri cate pro vistas co n este producto al mome nto de d espach o: El no ha cerio
pued e resu ltar en les iones gr aves o la muert e. Sol o par a el uso po r UNA S OLA per sona co ma de tentor pe rsonal c ontra c aidas. El
dispos itivo d ebe retir arse d el servi cio pa ra ser in specc ionado y recer tificati on lue go de hab er deten ido una caida o cuand o se ha ya
activa do el indi cator de im pacto. Si se req uiere el manual d e instruc ciones consu lte con M iller Fa ll Prote ction.
ADVE RTISSEM EN T: Vou s devez respecter les i nstruct ions d u fabrican t que vo us avez recues avec le produit : Dans le cas
contrai re, vou s risque z de bles sures graves ou meme lamort. Utiliser seule ment pa r UNE pe rsonne co mme arr et de chute
person nelle. L' appa reil doit etre mi s hors d ' u t ilisation p our insp ection et rec ertificati on apres avoir arrete un e chut e ou
lorsq ue l'indicateu r d' imp act a et e active. Co ntactez Miller F all Prot ection si vous av ez besoi n d'un nouvea u man uel.
LB388
Rev. D
MFP9350111