Honeywell Miller MightEvac Bedienungsanleitung Seite 13

5.3 Installation Procedure to Tripod
Step 1: Place bracket hook over adjustment pin.
Step 2: Rotate bracket toward Tripod leg until the top holes of the bracket pass the Tripod leg and
insert pin completely through both sides of the bracket. (NOTE: This pin will pass behind the
Tripod leg, not through it--see Fig. 2b.)
Step 3: Align the bottom holes in the bracket with holes in the Tripod leg and insert pin through bracket
and Tripod leg. Be sure the pin is completely through both the bracket and Tripod leg.
To remove the device, simply reverse the installation procedure. WARNING: Be careful not to remove
the pin that collapses the Tripod leg, as serious injury may occur.
Fig. 2a
Fig. 2b
13
(Ref. Fig. 2a and 2b)