Charging/Operating A Usb Device (See Fig . C); Maintenance And Cleaning - Parkside PAA 20-Li B2 Originalbetriebsanleitung

Charging/operating a USB device (see fig . C)

♦ Connect your USB device to the USB port
adapter .
♦ Press the ON/OFF switch
The control LED
trol LED lights up permanently to indicate the power supply .
Your device can now be charged or operated on the battery
adapter .
♦ To turn off the USB port
for around two seconds .
The LED light
USB device is disconnected .
The control LED
♦ If you are no longer using or charging your device, disconnect it
from the battery adapter

Maintenance and cleaning

WARNING! RISK OF INJURY! Disconnect the
appliance from the battery before cleaning.
Do not spray the appliance or place it in water.
Risk of injury due to electric shock.
■ The appliance is maintenance-free .
■ Use a dry cloth or brush for cleaning .
■ Do not use cleaning agents or solvents .
This could cause irreparable damage to the appliance .
NOTE
► Replacement parts not listed (such as carbon brushes,
switches) can be ordered via our service hotline .
■ 20 │ GB │ IE
to activate the battery adapter
flashes four times and then lights up . The con-
, press the ON/OFF switch
lights up briefly and the power supply to the
goes out after a short time .
.
of the battery
again
PAA 20-Li B2
.