Entsorgungshinweis; Battery Information; Technical Data - Grohe 26 640 Montageanleitung

,
Brause siehe Seite 8.
5 Jahre Garantie auf die gleich bleibende Funktion der
SpeedClean-Düsen.
Störung / Ursache / Abhilfe
Störung Ursache
Fernbedienung • Kopfbrause und Fernbedienung nicht
funktioniert nicht
Strahlart wechselt • Batterien in Kopfbrause leer
3x hin und her
LED der • Batterie in Fernbedienung leer
Fernbedienung
blinkt 3x
GB
Applications
Head shower with remote control for wireless diversion of
spray patterns.
General information
Installation and use are subject to applicable national
provisions.
No liability can be accepted for damage occurring due to
non-observance of the operating instructions.
Operating conditions
Interference sources
The transmitter/receiver unit operates in the ISM frequency
band (2.4 GHz). Installation in proximity to devices with the
same frequency band (e.g. Wi-Fi devices, HF components,
etc. [observe manufacturer documentation!]) should be
avoided.
Obstructions/barriers
Wireless reception can be impaired and interrupted under
unfavourable surrounding conditions, in buildings/rooms with
reinforced concrete walls, steel and iron frames or in proximity
to obstacles (e.g. furniture) made of metal.
Type of barrier
Wood, plastic
Water, bricks, marble
Plaster, concrete, glass,
solid wood
Metal

Battery information

Use the batteries supplied as standard for the initial start-up.
Ensure polarity is correct when inserting batteries! Only use
batteries of the same type. Always replace all batteries at the
same time, do not mix new and used batteries together. Do not
recharge used batteries, and do not attempt to reactivate them
using heat or other means. Rechargeable batteries may not be
used. Discharged batteries must be removed from the device
immediately, increased risk of leakage!
gepairt
Interference or screening
potential
Low
Medium
High
Very high

Entsorgungshinweis

Geräte mit dieser Kennzeichnung gehören nicht
in den Hausmüll, sondern müssen gemäß der
landesspezifischen Vorschriften getrennt entsorgt
werden.
Abhilfe
die folgenden Schritte müssen in weniger als 5
Minuten durchgeführt werden:
- Batterie aus Fernbedienung entnehmen,
30 Sekunden warten und neu einsetzen oder
ersetzen
- Batterien aus Kopfbrause entnehmen, 30 Sekunden
warten und neu einsetzen oder ersetzen
- Batterien tauschen
- Batterie tauschen

Technical data

• Flow pressure:
• Operating pressure:
• Test pressure:
• Temperature
- Hot water supply
- Recommended for energy saving
• Relative humidity:
• Ambient temperature:
• Radio frequency:
• Transmitter power:
• Remote control battery:
• Head shower batteries:
• Remote control rating:
Electrical test data
• Software class:
• Contamination class:
Installation
, see pages 3 and 4.
Pairing
Pairing refers to the initial coupling between two devices.
After inserting the batteries pairing mode is active for up to
5 minutes, the red LED on the remote control flashes. The
LED stops flashing if pairing has been successful.
Installing the head shower
When installing e.g. on plasterboard walls (not solid walls), you
must ensure that sufficient strength is provided through the
use of suitable reinforcement in the wall.
Installing the shower arm
See additional installation instructions enclosed.
10
min. 0.1 MPa
recommended: 0.15 – 0.5 MPa
max. 0.5 MPa
1.6 MPa
max. 70 °C
max. 80 %rH
15 – 45 °C
2.402 ... 2.483 GHz
< 10 mW
1x 3 V lithium battery
(type CR 2032)
3x AAA battery
60 °C
IP57
A
2