Grohe 26 640 Montageanleitung Seite 48

Неисправность/причина/устранение
Неисправность Причина
Пульт • Верхний душ и пульт дистанционного
дистанционного
управления не
функционирует
Тип струи • Аккумуляторные батареи в верхнем душе
меняется 3 раза
туда и обратно
Светодиод • Аккумуляторная батарея в пульте
пульта
дистанционного
управления
мигает 3 раза
USA CDN
Applications
Head shower with remote control for wireless selection
of spray patterns.
General information
Installation and use are subject to applicable national
provisions.
No liability can be accepted for damage occurring due
to non-observance of the operating instructions.
Operating conditions
Sources of interference
The transmitter/receiver unit operates in the ISM frequency
band (2.4 GHz). Installation in proximity to devices with the
same frequency band (e.g. Wi-Fi devices, HF components,
etc. [observe documentation by manufacturer!]) should
be avoided.
Obstructions/barriers
Wireless reception can be impaired and interrupted under
unfavorable surrounding conditions, such as in buildings/rooms
with reinforced concrete walls and/or steel and iron frames,
or in proximity to obstacles (e.g. furniture) made of metal.
Type of barrier
Wood, plastic
Water, brick, marble
Plaster, concrete, glass,
solid wood
Metal
Battery information
Use the batteries supplied as standard for the initial start-up.
Ensure the polarity is correct when inserting the batteries! Only
use batteries of the same type. Always replace all batteries
at the same time; do not mix new and used batteries. Do not
recharge used batteries, and do not attempt to reactivate them
using heat or by other means. Rechargeable batteries may
not be used. Discharged batteries must be removed from
the device immediately. These pose an increased risk
of leakage!
управления не сопряжены
разряжены
дистанционного управления разряжена
Interference or
shielding potential
Low
Medium
High
Very high
Устранение
Указанные действия необходимо выполнить в
течение 5 минут.
– Извлечь аккумуляторную батарею из пульта
дистанционного управления, подождать
30 секунд и снова вставить или заменить ее
– Извлечь аккумуляторные батареи из верхнего
душа, подождать 30 секунд и снова вставить или
заменить их
– Заменить аккумуляторные батареи
– Заменить аккумуляторную батарею
Compliance statement (part 15.19)
This device complies with part 15 of the FCC Rules and with
Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Warning (part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Tout changement ou toute modification qui ne serait pas
approuvé expressément par la partie responsable de la
conformité peut annuler l'autorisation d'utilisation de
l'équipement de l'utilisateur.
RF Exposure (OET Bulletin 65)
To comply with FCC RF exposure requirements for mobile
transmitting devices, this transmitter should only be used or
installed at locations where there is at least 7 7/8'' (20cm)
separation distance between the antenna and all persons.
Information to the User (Part 15.105 (b))
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
47