Assembly Instruction - attika RAIS 2:1 Bedienungsanleitung

English
Assembly instructions
Installation of stove:
NOTE:
• Decisions must be made concerning the positioning of the inlets and outlets of the
convection system. It must be ensured that area requirements are respected.
• There may be discolouration of the wall above the stove doors and the exhaust
apertures of the convection system. This is due to rising hot air.
• RAIS accepts no responsibility for installation or consequential damages.
Remove the stove from the pallet and position the stove in the desired location on a
suitable surface. If you wish the stove in a higher position use adjustable legs (accesso-
ries can be purchased from your RAIS dealer).
The stove can be aligned using screws, so that the glass
on the upper side of the door is horizontal in the closed position and the glass surface
is vertical in the closed
position.
Remove the covers and doors from the packaging. Take care of the glass on the doors
as they are easily damaged by knocks and impacts . Leave the protective tape on the
stainless steel damper handle. Protect the painted surfaces of the stove against cement
and paint spray.
Attach the non-insulated part of the chimney to the flue collar in the convection cham-
ber.
It is important that there is no leakage between flues and stove. Therefore it is
recommended to seal with a washer during the assembly.
Install the insulated part of the chimney and connect to a brick chimney, if possible.
Mount the fresh air connection to the spigot at the bottom of the stove, if this is to be
connected.
If you choose to install pipes to the convection system outlet flue spigots, it would be
useful to do this before installation.
The stove may either be installed in a fireproof wall panel or brick wall.
After the wall is completely established and painted, the cover panels and doors are to
be attached, if required.
The covers are adjusted to the maximum wall thickness from the factory.
The screws in the top and bottom are to be slackened.
The covers are to be pushed against the wall.
Check if the cover is parallel to the wall and the door glass when closed - if necessary,
adjust the cover.
Covers in individual measurements may also be delivered, if required.
Contact your RAIS dealer. This may be ordered with the stove.
10
attika
RAIS/ - User manual for RAIS 2-1