Makita UM164D Bedienungsanleitung Seite 16

1. Oval holes that are overlapped
2. Hole in the base plate of shear blades
3. Base plate
010907
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
Fig.24
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
Fig.25
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the
base plate of the shear blades is set in place.
Fig.26
Tighten two screws with a coin or similars firmly.
Fig.27
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
Fig.28
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
Fig.29
At this time, make sure that the locking lever fits in the
groove in the undercover.
CAUTION:
Never use the tool without installing the undercover
•
on it.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.
3
1
2
on the
on the locking
Removing the hedge shear blades
Fig.30
CAUTION:
Install the blade cover before removing or installing
•
the shear blades.
Reverse the tool.
Fig.31
To remove the shear blades, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
Fig.32
Take out the undercover from the tool.
Fig.33
Loosen two screws with a coin and similars and remove
the shear blades.
NOTE:
Do not remove the screws. Without removing the
•
screws loosened, shear blades can be removed.
Fig.34
Remove the crank from the shear blades.
NOTE:
The crank may remain in the tool.
•
Fig.35
NOTE:
In the 2-way usage, the removed grass shear
•
blades need to be sheared in the blade storage
case and stored for future use.
OPERATION
Refer to the Important Safety Instructions before
operation.
on
CAUTION:
Be careful not to accidentally contact a metal fence
•
or other hard objects while trimming. The blade will
break and may cause serious injury.
Also, be careful for the shear blade not to contact
•
the ground.
Overreaching with a hedge trimmer, particularly
•
from a ladder, is extremely dangerous. Do not work
from anything wobbly or infirm.
Fig.36
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
CAUTION:
Do not cut off dead trees or similar hard objects.
•
Failure to do so may damage the tool.
Do not trim the grass or weeds while using hedge
•
shear blade. The shear blade may entangle the
16
on the undercover
on the locking lever.