Ryobi RLT-5030AH Bedienungsanleitung Seite 18

RLT-5030AH_25 lgs
GB
F D E I
SERVICE
Servicing requires extreme care and knowledge and
should be performed only by a qualified service technician.
For service we suggest you return the product to your
nearest AUTHORIZED SERVICE CENTRE for repair.
When servicing, use only identical replacement parts.
WARNING
Observe all normal safety precautions related to
avoiding electrical shock.
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator's manual.
Save this operator's manual and review
frequently for continuing safe operation and
instructing others who may use this product.
WARNING
The operation of any power tool can result in
foreign objects being thrown into your eyes, which
can result in severe eye damage. Before beginning
power tool operation, always wear safety goggles
or safety glasses with side shields and a full face
shield when needed. We recommend Wide Vision
Safety Mask for use over eyeglasses or standard
safety glasses with side shields. Always use eye
protection.
SAVE THESE INSTRUCTIONS.
SPECIFICATIONS
RLT-5030AH
Voltage . . . . . . . . . . . . . . . . . . . . . . . .230/240 V ~ 50 Hz
Nameplate power . . . . . . . . . . . . . . . . . . . . . . . . .500 W
No Load speed . . . . . . . . . . . . . . . . . . . . . .11,000 min-
Cutting line . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.4 mm
Max. cutting path . . . . . . . . . . . . . . . . . . . . . . . .300 mm
Sound power level . . . . . . . . . . . . . . . . . . . . . . .94 dB(A)
DESCRIPTION
1. Main handle
2. Lock-off button
3. Trigger
4. Front handle
5. Electric power cord
6. Live tool indicator
7. Handle lock
13/01/06 15:42 Page 12
P NL S DK N FIN GR HU
English
1
CZ RU RO PL SLO HR TR EST LT
8. Height adjustment button
9. Lower shaft
10. Upper shaft
11. Steel wire guide
12. Rotating release
13. Motor housing
14. Foot pedal
15. Safety guard
16. Spool
17. Bump knob
18. Nylon line
19. Bump head
20. Cut-off blade
21. Bolt
22. Washer
23. Knob nut
ASSEMBLY
The line trimmer is supplied with some components
not assembled. To assemble these, proceed as follows:
SHAFT ASSEMBLY (Fig. 2)
Remove the rubber top and the paper tag from the
■
lower shaft.
Check the cable is in good condition. (A section of the
■
main cable is protected by a sheath. Do not mistake
this as damage.)
WARNING
If the cable is damaged, cut or scarred in any
way, take the product back to the retailer
immediately.
By clutching the upper part of the line trimmer under
■
your right arm and with your left hand holding the
lower shaft (9), carefully position the upper shaft (10)
over the lower shaft.
With your right thumb, push forward the height
■
adjustment button (8) then gradually lower the upper
shaft over the lower shaft. Turn/rotate the upper shaft
as necessary to ensure it goes onto the lower shaft in
the correct orientation.
As you insert the upper part over the lower part, take
■
care not to damage the cable and that the cable
resides comfortably without strain inside the shafts.
Note: This shaft is designed for one time assembly.
It is not possible to disconnect the tubes once they
have been assembled/ fixed.
12
LV SK BG