Pump Heads And Hydraulic Connections - Knauer WellChrom HPLC Pump K-1001 Handbuch

Setup of the HPLC Pump K–1001
Fig. 3
The display shows information about the current status of the pump, such as
the flow rate, the measured pressure or the current status of the running
program. It serves as a control instrument when entering data.
Pumping can be started or stopped by pressing the key START/STOP, see
{2.1}, using the preset values. The foil key PURGE, see {2.2}, allows immediate
access to the purging function of the pump.
You can use the keys for entering data and control the execution of programs.
Detailed information is given in see „Control of the HPLC Pump K–1001" on
page 11 and „Programing the HPLC Pump K–1001" on page 21.

Pump Heads and Hydraulic Connections

All hydraulic connections are on the front panel of the HPLC Pump K–1001, see
Abb. 3. For connecting eluents to the pump head see section „Connecting the
HPLC Pump K–1001 to other Instruments" and Fig. 19 on page 26.
{4.4}
{4.3}
{4.2}
{4.1}
{3.7}
3 Pump Head
3.1 Piston backflushing capillaries 4.1
3.2 Eluent inlet
3.3 Head set screws
3.4 Label indicating the maximum
flow rate
3.5 Inlet valve housing
3.6 Outlet valve housing
3.7 Eluent outlet to tranducer
Pump Head and tranducer with Purge valve
{3.1}
4 Transducer with Purge Valve
Inlets to tranducer
4.2 De-areation capillary,
(Purging outlet)
4.3 De-areation screw for opening
purge valve
4.4 Eluent outlet to column
9
{3.2}
{3.6}
{3.3}
{3.4}
{3.5}