Rear Panel View Of The Hplc Pump K-1001; Connection To Main Power - Knauer WellChrom HPLC Pump K-1001 Handbuch

10
Rear Panel View of the HPLC Pump K–1001
Fig. 4

Connection to Main Power

{5.9}
{5.8}
5 Rear panel elements
5.1 Fuse compartment
5.2 Power connector
5.3 ON/OFF switch
5.4 RS-232 interfaces
5.5 Socket prepared for Ethernet
connection
Rear Panel of the HPLC Pump K–1001
The WellChrom HPLC Pump K-1001is equipped with an universal power supply
for input voltages ranging from 90 to 260 Volts AC. A manual setting of the
supply voltage is not required.
Make sure that the main power supply is properly grounded and a correct
three-pronged power cable is used. Connecting the instrument to faulty
power sockets can cause damages.
Connect the power cable to the socket on the rear of the instrument, and switch
on the device with the ON/OFF key, see {5.2} and {5.3} in Fig. 4.
Setup of the HPLC Pump K–1001
{5.10} {5.1} {5.2} {5.3}
5.6 Ventilator
5.7 Serial number
5.8 Terminal strip REMOTE con-
nections
5.9 Terminal strip REMOTE con-
nections
5.10 Plug for interconnection of
Solvent Organizer K-1500
{5.4}
{5.5}
{5.6}
{5.7}