Knauer WellChrom HPLC Pump K-1001 Handbuch Seite 13

Control of the HPLC Pump K–1001
Main menu
Fig. 8
SOP 3
Structure of the SETUP menu
Selecting a Gradient Mode
This SOP applies to the HPLC Pump K–1001 Firmware Revision 6.0X. Use this
SOP for selecting a gradient mode.
1. Select „GRADIENT MODE" in the SETUP Menu.
2. Select the desired mode of operation.
3. If you select either high or low pressure gradient (i. e. HPG or LPG) you
need to specify the channels of used solvents:
Low Pressure Gradient: Choose valves A to D
High Pressure Gradient: Choose pump names HPG A to HPG D
4. Move to the second line by pressing
LPG mode) or pumps actually present (for HPG mode) on the
corresponding positions by pressing
programs and define the number and names of solvents used in any
gradient.
and choose valves A to D (for
or . This selection will apply for
13