Knauer WellChrom HPLC Pump K-1001 Handbuch Seite 22

22
Fig. 16
SOP 14 Execution of Programs
Load Edit Prog
Prog Clear 0
Link 01
A
OFF
View
Hold 0
Run 1
Load Edit Prog
Prog Clear 0
Link 01
B
OFF
View
Hold 0
Run 1
Load Edit Prog
Prog Clear 0
Link 01
C
OFF
View
Hold 0
Run 1
Load Edit Prog
Prog Clear 0
Link
01
D
OFF
View
Hold 0
Run 1
Display of sinle steps, when creating a program
(see „Example for creating a program"on page 24)
This SOP applies to the HPLC Pump K–1001 Firmware Revision 6.0X.
1. Load the program you want to execute by entering the program number in
the LOAD PROG-field. Confirm with any arrow key.
2. Press START key to start the pump. The display changes to ON and the
pump begins continuous operation with the parameters specified in the first
program line.
3. Position cursor on field ON
4. Start the program by pressing the numeric key 1. The display changes to
RUN.
5. During execution of programs you can press key 0 to freeze the current
status of the pump. The display changes to HOLD and the field TIME is
blinking.
6. If you press 1 you can activate program execution again or you can press
STOP to abort execution.
During program execution the current solvent composition can be
observed in fields % A and % B. At the end of the program the pump
returns continuous pumping with the parameters of the first line, ON is
displayed.
Programming the HPLC Pump K–1001
Flow Pressure Events
[ml/min] [0.1 Mpa] off 0
07 100.0 |200| 0 0 0 0 0 0 0 0
000.00 100 0
Time %A
[min]
Flow Pressure Events
[ml/min] [0.1 Mpa] off 0
07 100.0 |200|
000.00 90
Time %A
[min]
Flow Pressure Events
[ml/min] [0.1 Mpa] off 0
07 - - -.- |200| -- -- -- -- -- -- -- --
***.*
- -
Time %A
[min]
Flow Pressure Events
[ml/min] [0.1 Mpa] off 0
07 _ _ _._ |200| _ _ _ _ _ _ _ _
020.0 10
Time %A
[min]
on 1 2
Setup
GLP
%B %C %D
on 1 2
0 0 0 0 0 0 0 0 Setup
10
GLP
%B %C %D
on 1 2
Setup
- -
GLP
%B %C %D
on 1 2
Setup
90
GLP
%B %C %D