Specifications - Makita M8100 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Grip base
1-2. Teeth
1-3. Side grip (auxiliary handle)
1-4. Protrusion
1-5. Loosen
1-6. Tighten

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Explanation of general view
2-1. Drill chuck
2-2. Chuck key
3-1. Sleeve
3-2. Ring
4-1. Side grip
4-2. Depth gauge
Model
Concrete
Wood
Steel
-1
)
Overall length
Net weight
Safety class
) : 98 dB (A)
pA
) : 109 dB (A)
WA
2
) : 16.5 m/s
h,ID
2
M8100
296 mm
2.1 kg
ENE039-1
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
ENF002-2
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1 WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG900-1
is running idle in addition to the trigger time).
3
4-3. Grip base
5-1. Switch trigger
5-2. Lock button
6-1. Reversing switch lever
7-1. Action mode changing lever
M8101
16 mm
30 mm
13 mm
0 - 3,200
0 - 48,000
295 mm
2.0 kg
/II
2
) : 3.0 m/s
h,D
2
ENG901-1