Specifications; Drill Safety Warnings - Makita DA4031 Betriebsanleitung

ENGLISH
(Original instructions)
1 Switch trigger
2 Reversing switch lever
3 Speed change knob
4 Pointer
5 Lock button
6 Mark
7 Motor housing

SPECIFICATIONS

Model
Capacities
Wood
Augerbit .................................................................................. 38 mm
Self-feed bit ................................................................ High: 65 mm
Hole saw................................................................................. 152 mm
Steel .......................................................................................... 13 mm
-1
No load speed (min ) ...................................................... High: 1,200
Overall length ............................................................................... 462 mm
Overall length (with an extended spade grip)............................... 536 mm
Net weight .................................................................................... 6.3 kg
Safety class ..................................................................................
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for drilling in wood, metal and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
SAFETY WARNINGS
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.

DRILL SAFETY WARNINGS

Safety instructions for all operations
1. Use the auxiliary handle(s). Loss of control can
cause personal injury.
2. Brace the tool properly before use. This tool pro-
duces a high output torque and without properly
bracing the tool during operation, loss of control may
occur resulting in personal injury.
4
Explanation of general view
8 Lock button
9 Handle
10 Side grip
11 Spade grip
12 Wrench holder
13 Hex wrench
14 Chuck key
Low:
Low:
3.
ENF002-2
4.
5.
6.
7.
GEA010-2
8.
9.
10. If the drill bit cannot be loosened even you open
Safety instructions when using long drill bits
GEB172-1
1.
15 Reaction
16 Forward
17 Reverse
18 Limit mark
19 Screwdriver
20 Brush holder cap
DA4031
118 mm
300
/II
Hold the power tool by insulated gripping sur-
faces, when performing an operation where the
cutting accessory may contact hidden wiring or
its own cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of the power
tool "live" and could give the operator an electric
shock.
Always be sure you have a firm footing. Be sure
no one is below when using the tool in high loca-
tions.
Hold the tool firmly.
Keep hands away from rotating parts.
Do not leave the tool running. Operate the tool
only when hand-held.
Do not touch the drill bit or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
the jaws, use pliers to pull it out. In such a case,
pulling out the drill bit by hand may result in injury by
its sharp edge.
Never operate at higher speed than the maxi-
mum speed rating of the drill bit. At higher
speeds, the bit is likely to bend if allowed to rotate
freely without contacting the workpiece, resulting in
personal injury.