Cruise Control - Skoda Octavia (5E) Handbuch

Cruise Control

The accessories are intended for professional fitting. ŠKODA AUTO recommends having the
assembly done by authorized service partners.
Cruise control for additional mounting is functionally identical with the extra equipment
mounted directly in the manufacture - Package 8T2.
EN
Important. The set is designed primarily for vehicles equipped with back wiper. The set
can be also used in vehicles without the back wiper but the control of the back wiper on
the switch underneath the steering wheel with the cruise control will be functionless.
This fact has no effect on correct function of the vehicle but the customer must be noti-
fied yet prior to the set assembly.
5E0 054 690 - Cruise Control for vehicles without an on-board computer,
5E0 054 690A - Cruise Control for vehicles with an on-board computer.
Advice. See the vehicle Service Instructions where the description of
controlling the Cruise Control can be found.
List of parts (Fig. 1)
Part name
Change-over switch below the steering wheel
with the control of the Cruise Control
Interconnecting wire
Tightening tape
Fitting instructions
Advice. The right-hand steering Cruise Control is connected in the
same manner as the left-hand steering Cruise Control. Only the
interconnecting wire leading differs.
Perform the disassembly and reassembly of individual parts according to the ŠKODA
workshop manual.
Have the car battery disconnected during the fitting (when a coded car radio is in the car,
find out its code first).
Dismantle at the left-hand steering:
- the upper and lower panel of the steering rod,
- the steering wheel,
- the side piece of the instrument panel,
- the left lower panel A-pillar panel on the driver's side,
- the knee airbag, if included in the equipment of the car.
Dismantle at the right-hand steering:
- the upper and lower panel of the steering rod,
- the steering wheel,
- instrument panel,
20
Pieces Position
1 A
1 B
10 C
1 D