h) Selecting Lamp Mode
Here you can choose if the lamp is to be activated if the area is not bright enough.
Note:
Settings are not possible while a recording is running.
• Briefly push the button „M" (9), the camera icon will flash at the upper left of the display.
• Push the button „8" (10) briefly 4x until the display shows either „oFF" or „Auto".
• Briefly push the button „5" (12) to confirm; the display „oFF" or „Auto" will flash.
• Use the buttons „8" (10) or „2" (11) to select the desired setting.
„oFF"
The lamp is deactivated
„Auto" The lamp is automatically activated if the brightness is too low
• Briefly push the button „5" (12) for confirmation.
• Briefly push the button „M" (9) to leave setting mode.
40