E) Inserting Memory Card; F) Activating Mains Voltage - Renkforce 1007598 Bedienungsanleitung

e) Insert memory card
Open the rubber cover (13) for the memory card slot and insert a memory card of type SD (max. 2 GByte) or
SDHC (max. 16 GByte) in the correct orientation (the contact strips of the memory card must point towards
the buttons), so that the memory card latches.
Close the memory card slot again with the rubber cover.
f) Switching on the Mains Voltage
• After the surveillance camera is completely installed and connected, switch on the mains voltage.
• The luminaire in the surveillance camera must light up now (self-test). After about 90 seconds, the lumi-
naire goes out again and the surveillance camera is ready for operation again.
Observe that the present settings are lost when the mains voltage is switched off (e.g. date/time).
The surveillance camera therefore should be connected to the mains voltage permanently.
35