2-Speed Gearbox; Use; Switching On/Off; Setting The Rotational Speed - Parkside PABS 20-Li D5 Originalbetriebsanleitung

2-speed gearbox

CAUTION!
► Operate the speed selector switch
when the appliance is at a standstill. Other-
wise the appliance could be damaged.
In first gear (speed selector switch
tion 1) (see fig. I)
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (speed selector switch
position 2) (see fig. J)
you can reach a speed of approx. 1400 rpm for
carrying out drilling work

Use

Switching on/off
Switching on
♦ Press and hold the ON/OFF switch
up the appliance (see fig. K).
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦ Release the ON/OFF switch
the appliance.

Setting the rotational speed

The ON/OFF switch
control. Press the ON/OFF switch
low speed. Increasing the pressure increases the
speed (see fig. K).
NOTE
► The integrated motor brake ensures that the
appliance stops quickly.
│ GB │ CY
■ 8
only
in posi-
to start
lights up when the
is pressed lightly or fully.
to switch off
has a variable speed
lightly for a

Changing the direction of rotation

♦ Change the direction of rotation by pressing
the rotation direction switch
or right (see fig. L).

Tips and tricks

Tip! How to do things correctly.
♦ Before operation, check whether the screw or
drill insert is correctly fitted, i.e. centred in the
drill chuck.
in
♦ Screw bits are labelled according to their di-
mensions and their shape. If you are uncertain,
always check first whether the bit fits tightly in
the screw head without any play.
Torque
♦ Smaller screws/bits can be damaged if you
set too high a torque or too high a speed.
Hard screw joints (in metal)
♦ Particularly high torques occur, e.g. in metal
screw joints made using drive sockets.
Select a low rotational speed.
Soft screw joints (e.g. in soft wood)
♦ Here, too, use a low speed to avoid damaging
the wood surface when it comes into contact
with the metal screw head. Use a countersink.
When drilling in wood, metal and other
materials, observe the following
♦ Use a high speed for drill bits with a small
diameter and a low speed for drill bits with
a large diameter.
♦ Select a low speed for hard materials and
a high speed for soft materials.
♦ Secure or fasten the workpiece in a clamp
or vice (if possible).
♦ Mark the spot where you want to drill with a
punch or nail. Select a low rotational speed
when you start drilling.
♦ Pull the rotating drill bit out of the hole several
times to remove dust and chips and clear the
hole.
towards the left
PABS 20-Li D5