Stopping Vacuuming; Controlling The Power; Starting Turbo Mode; Stopping Turbo Mode - Bosch BGB6 serie Gebrauchsanleitung

en Basic operation

Stopping vacuuming

Press ⁠ .
▶
a The appliance stops and the status
display pulses white.
a The setting for the power level is
retained.

Controlling the power

Press or
1.
→ Fig.
11
a The power level is increased or de-
creased.
Turn the telescopic tube with air
2.
flow regulator to the required posi-
tion.
→ Fig.
12
a The power is controlled continu-
ously.

Starting turbo mode

For particularly stubborn dirt, you can
use turbo mode.
Press ⁠ .
▶
a Turbo mode starts.

Stopping turbo mode

Press ⁠ .
▶
a The appliance switches to the
power level that was previously
set.

Setting the floor tool

Use the switch to set the floor
▶
nozzle to the required base.
→ Fig.
13

Parking the appliance

Tip: When taking shorter breaks from
vacuuming, the floor nozzle can be
placed in the parking aid.
1
Depending on the appliance specifications
36
⁠ .
Slide the hook on the floor nozzle
▶
into the parking aid.
→ Fig.
14
Stopping and carrying the appli-
ance
Switch off the appliance.
1.
→ "Switching off the appliance",
Page 35
Stand the appliance upright on its
2.
end.
Slide the hook on the floor tool into
3.
the parking aid.
→ Fig.
15
To overcome obstacles, carry the
4.
appliance by the handle.

Vacuuming with accessory

Place the required nozzle onto the
1.
telescopic tube or the handle.
After use, take the nozzle that is
2.
used from the telescopic tube or
remove from the handle.
Vacuuming with the Multi-Use-
1
Brush
Note: Do not remove the Multi-Use-
Brush after use. The suction power is
not restricted by the fitted Multi-Use-
Brush.
ATTENTION!
Vacuuming without the bristle ring
pushed down can damage the sur-
face.
Never vacuum with the bristle ring
▶
pushed up.
Push the Multi-Use-Brush onto the
1.
handle or the tube and lock it in
place.
→ Fig.
16