VOLTCRAFT Charge Manager 2005 Bedienungsanleitung Seite 16

Insulation class 2 (double insulated)
Only for use in dry interior environments
For safety and licensing reasons (CE), unauthorised conversion and/or modification
of the device is not permitted.
Consult suitably qualified staff, if you have doubts about how the equipment opera-
tes or about how to connect it safely.
Measuring instruments and accessories are not toys and have no place in the hands
of children!
In commercial institutions, the accident prevention regulations of the Employer's Lia-
bility Insurance Association for Electrical Systems and Operating Materials are to be
observed.
In schools, training centres, computer and self-help workshops, handling of measu-
ring devices must be supervised by trained personnel in a responsible manner.
Prior to each setup, check your charging device and its cables for damage(s). Never
use the device if the protective insulation is damaged (ripped, torn off etc.).
Do not operate the charging station in areas or unfavourable conditions where com-
bustible gases, vapours or dust are or may be present.
If you have reasons to assume that the safe operation is not possible any longer, take
the device out of operation immediately and protect it against inadvertent operation.
Reasons to assume that the safe operation is not possible any longer include the fol-
lowing ones:
- the appliance is visibly damaged,
- it does not function any longer and
- the appliance has been stored for long periods of time under unfavourable condi-
tions or
- the appliance has been subject to considerable stress in transit.
Do not switch on the charging device immediately after it has been taken from a cold
to a warm environment. The condensation water generated could destroy the device.
Allow the device to reach room temperature before switching it on.
16