In Case Of; Cleaning - Carrier 51AKP Gebrauchsanweisung

In case of...

If the unit appears not to be operating
correctly, before calling a service
technician please check that...
Check that the filters are not dirty.
If the air conditioner does not respond to
the controls remove the plug from the
electricity socket and then replace it again.

Cleaning

Hook
Periodically clean the air filters at the back
of the unit, every 30 days or more often if
necessary. Plug out the power supply
before cleaning. To pull out the filters from
their position press the two hooks of the
grille to take off the card of air inlet grille,
then take out the air filter.
Drainage
pipe
Empty the remaining condensate water
through the drain tube at the back of the
indoor unit, then plug the tube and stow it.
... the operating instructions in the
literature have been followed...
If the LCD displays "
supply is unstable: remove the plug from
the electricity socket, wait 10 minuts and
then replace it again.
Hook
Air inlet
grille
First clean the filters with a vacuum
cleaner then rinse and dry the filters.
Reinsert the filters correctly in their position.
Clean the active carbon and silver plasma
filter only with the vacuum cleaner instead
of Water.
Rear plate
Rubber
plug
Clamp
SET TEMP
" the power
If the unit is not used for extended periods:
• Plug out the power supply.
• Remove the residual condensation water through the
small drain pipe situated at the rear of the indoor unit,
then re-fit the plug and reposition the small pipe.
• Clean the filters.
• Rewind the electrical cable on the hook provided at
the rear.
• Hang the outdoor unit on the back of the indoor unit (split
model).
• Insert the two ends of the flexible pipe into their
respective holes (stand-alone model).
• Cover the air conditioner with a bag.
E N G L I S H
...the main switch is on, there are no
breaks in the electrical cable and that the
plug is correctly inserted in the socket...
SET TEMP
If the LCD displays " " the water tank is
full: remove the plug from the electricity
socket, drain out the water wait 3 minutes
and then replace the plug again.
To clean the appliance enclosure use only
moist cloth and soap.
NEVER use spray or flammable liquids.
GB - 9