Storage - Silvercrest SMAS 500 A1 Bedienungsanleitung

Clean the container
to prevent the milk residue from drying on. Proceed as follows:
♦ For initial basic cleaning, fill the container
little detergent (the whisk
MAX - markings
♦ Start the appliance so that the whisk
Afterwards, rinse the appliance out with clean water.
For a thorough cleaning and for the initial cleaning, proceed as follows:
♦ Remove the whisk
appliance with warm water and mild detergent if required. Wipe the interior
out with a soft cloth or sponge. Pay special attention to the area around the
drive shaft. Afterwards, rinse out the appliance thoroughly with clean water
and dry it.
♦ Pull the sealing ring
water. Rinse off detergent residues with fresh water and dry the parts well.
Push the sealing ring
♦ Clean the whisk
fresh water. Allow it to dry.
♦ Clean all exterior surfaces, the base
damp cloth. For stubborn soiling, use a mild detergent on the cloth. Wipe
off any detergent residues using a cloth moistened only with clean water.
Always dry the appliance thoroughly before using it again.

Storage

♦ Allow the appliance cool down completely before putting it into storage.
♦ Wind the power cable around the cable retainer
♦ Store the appliance in a clean and dry location.
SMAS 500 A1
immediately after it has cooled down each time you use it
is inserted). While doing so, note the MIN and
(= 300 ml).
swirls through the water for a while.
from the appliance and clean the inside of the
off the lid and clean both parts in mild soapy
back onto the lid
in mild soapy water and then rinse it thoroughly with
and the mains cable with a slightly
with water and, if required, a
.
in a clockwise direction.
GB │ MT │ 27 ■