Designated Use - Abicor Binzel ABITIG GRIP Betriebsanleitung

TIG welding torch
1 Identification
The manual welding torches ABITIG
welding using tungsten electrodes and inert gases. They are available as liquid-cooled or air-
cooled version.The liquid-cooled model requires a recirculating cooling unit. They consist of the
torch neck with equipment parts and wearing parts, handle and cable assembly with central
connector. They correspond to the directive EN 60 974-7 and are not considered to be devices
having their own functions. Arc welding can only be carried out in connection with a welding
power supply.
1.1 Marking
This product fulfills the requirements that apply to the market to which it has been introduced. A
corresponding marking has been affixed to the product, if required.
2 Safety
The attached safety instructions must be observed.

2.1 Designated use

• The device described in these instructions may be used only for the purpose and in the
manner described in these instructions. In doing so, observe the operating, maintenance
and servicing conditions.
• Any other use is considered improper.
• Unauthorized modifications or changes to enhance the performance are not permitted.
2.2 Classification of the warnings
The warnings used in the operating instructions are divided into four different levels and shown
prior to potentially dangerous work steps. Arranged in descending order of importance, they
have the following meanings:
DANGER
Describes an imminent threatening danger. If not avoided, this will result in fatal or extremely
critical injuries.
WARNING
Describes a potentially dangerous situation. If not avoided, this may result in serious injuries.
BAL.0093 • 2019-06-19
®
GRIP are used in industry and trade for inert gas
1 Identification
EN - 3