AirSep FreeStyle Gebrauchsanweisung Seite 206

Filters
Air enters FreeStyle through an air intake filter located under the cover on the lower front of the
oxygen concentrator. (See Figures 21 and 22.) This filter prevents dust and other large particles in
the air from entering the unit. Before you operate FreeStyle, make sure this filter is clean and
positioned correctly.
Figure 21: Removal of Air Intake Filter Cover
Do not operate the Oxygen Concentrator without the air intake filter in place. If a second filter is
provided, insert the "replacement" filter before you clean the dirty filter. Clean the dirty filter in a
warm soap and water solution then dry thoroughly prior to use.
Use only AirSep Part No. FI144-1 as the air intake filters for this unit.
NOTE
The Manufacturer does not recommend the sterilization of this equipment
MN131-1 rev C
Figure 22: Removal of Filter from Filter Cover
EN-24