Changing The High And Low Beam Bulbs - Ducati MULTISTRADA 620 Anleitung- Und Instandhaltungsheft

Changing the high and low beam bulbs

Before replacing a burnt-out bulb, make sure that the new
one complies with voltage and wattage as specified in the
"Electrical System" paragraph on page 87. Always check
that the new bulb works before refitting removed parts.
Figure fig. 53 shows the position of the low beam (LO),
high beam (HI) and parking light (1) bulbs.
E
To access the headlight bulbs, release the top and
bottom springs (2) under the instrument panel at the side
of the fixed fairing (fig. 54), and open the shell (3).
Notes
For the sake of clarity the headlight is shown
disassembled from the vehicle.
64
1
2
3
fig. 54
LO
HI
fig. 53
2 3
3 2