Commissioning; Connecting The Device - Vieweg DC 200 Bedienungsanleitung

Operating Instructions DC 200

4 Commissioning

4.1 Connecting the device

• Unpack the dispensing controller and set it up on a
worktable where it will be used . Preferably in a dry location .
• Supply the dispensing unit with compressed air .
Insure that the compressed air supply is clean (5-micron filter
must be used) and dry . Condensation in the airline will
damage the unit and limit the warranty .
• Using the airline hose supplied with the unit, connect the
compressed air inlet on the back of the dispensing unit to
your compressed air supply .
• Connect the power cable to the power connection on back
of the unit .
• The unit can be operated either by finger switch (sold separa-
tely), foot switch or a control cable, if the dispensing controller
is to be integrated with a dispensing robot . All these cables are
inserted into the socket for the foot switch on the back of the
unit .
• Switch on the controller . When the Power LED is lit up, the
unit is ready for operation .
• Seal a barrel filled with dispensing material using the barrel
adapter by placing the adapter across the barrel and then
locking it with a 90° turn .
• Select a suitable luer lock dispensing needle and attach it
onto the barrel .
• Connect the hose from the barrel adapter to the compressed
air outlet of the DC 200 . By turning the regulator knob in a
"clockwise" direction, make sure to end up always "bringing up"
the pressure to the desired setting to have the correct pressure
value .
17
VIEWEG
EN