Parkside PPS 40 B2 Bedienungs- Und Sicherheitshinweise Seite 10

Safety instructions
WARNING!
f RISK OF SERIOUS
INJURY OR DEATH
FOR INFANTS AND
CHILDREN! Never leave
children unsupervised near
packaging material. There is
a risk of suffocation.
This device may be used by
„
children aged 16 years and
older, and by persons with
reduced physical, sensory or
mental capacities, or a lack of
experience and knowledge,
if they are supervised or have
been instructed in how to use
the device safely and under-
stand the dangers that may
arise when using it. Do not
allow children to play with the
device. Cleaning and day-to-
day maintenance must not be
performed by children without
supervision.
Repairs or/and maintenance
„
work must only be carried out
by qualified electricians.
Only use the cutting cable
„
provided in the scope of
delivery.
During operation, the device
„
should not be positioned
directly on the wall, covered
or jammed between other
10 GB/IE/NI
devices so that sufficient air
can be absorbed through the
ventilation slats. Makes sure
that the device is correctly
connected to the supply
voltage. Avoid any form of ten-
sile stress of the power cable.
Disconnect the plug from the
socket prior to setting up the
device in another location.
If the device is not in opera-
„
tion, always switch it off by
pressing the ON/OFF switch.
Place the electrode holder on
an insulated surface and only
remove it from the holder after
allowing it to cool down for
15 minutes.
Hot metal and sparks are
blown off from the cutting arch.
The flying sparks, hot metal
as well as hot objects and hot
device equipment can cause
fires or burns. Check the working
environment and make sure the
workplace is suitable prior to
using the device.
Remove all flammable material
„
within 10 m of the plasma
cutter. If this is not possible,
cover the objects meticulously
using suitable covers.
Do not make cuts in places
„
where flying sparks could