Technical Specifications; Safety Instructions - Parkside PPS 40 B2 Bedienungs- Und Sicherheitshinweise

17 On/off - switch
I switched on
O switched off
18 Condensation water tank
19 Manometer
20 Compressed air connection
21 Rotary knob to regulate the pressure
22 Hose clamp
23 Removable roller guide
Locking screws
23a
Fixing screws
23b
Guide rollers
23c

• Technical specifications

Output: 15–40 A
Input: 230 V~ 50 Hz
Weight: approx. 5.0 kg
Dimensions 341 × 116 x 237 mm
Insulation class: H
Duty Cycle : 35 % at 40 A (25 °C)
*
20 % at 40 A (40 °C)
"Real" cutting
capacity: 0.1 mm–12 mm
(depending on the material)
Copper:1–4 mm
Stainless steel: 1–8 mm
Aluminium:1–8 mm
Iron: 1–10 mm
Steel: 1–12 mm
Working pressure: 4–4.5 bar
(4 bar preset)
Changes to technical and visual aspects of
the product may be made as part of future
developments without notice. Accordingly,
no warranty is offered for the physical
dimensions, information and specifications
in these operating instructions. The operating
instructions cannot therefore be used as the
basis for asserting a legal claim.
Introduction / Safety instructions
Duty Cycle = is the percentage of the
*
operating time, in which the machine can be
used continuously under normal temperature
conditions. In relation to a 10-minute time
period this means, for example, that with a
duty cycle of 20%, that it can be used for
2 minutes and then there should be a break
of 8 minutes. If you exceed the duty cycle
values then this will trigger the overheating
protection which will bring the device to a
stop until it has cooled down to the normal
working temperature. Exceeding the duty
cycle values continuously can damage the
device.

• Safety instructions

WARNING!
f Please read through the
operating instructions care-
fully before use. Familiarise
yourself with the device, its
proper use and the safety
notes based on these operat-
ing instructions. These form
part of the product and must
be available at all times.
GB/IE/NI 9