Cleaning The Motor Protection Filter - Philips FC8149 Bedienungsanleitung

English
14
1
2
2
1
Never clean the HEPA exhaust filter with a brush.
Note: Cleaning does not restore the original colour of the filter, but does restore
its filtration power.
4 Remove the foam filter and rinse it under a tap.
5 Carefully shake the water from the surface of the HEPA dust
container filter. Let the HEPA dust container filter and the foam
filter dry completely before you put them back into the vacuum
cleaner.
6 Place the foam filter back in the dust container.
7 To place the HEPA dust container filter back into the dust container,
press the large lug onto the spring-loaded button, insert the small
lugs into the hinges (1) and press the latch home until it locks in
place ('click') (2).
hEpa exhaust filter
1 To open the HEPA exhaust filter grille, grab the tabs and pull the
grille upwards to remove it from the appliance.
2 Remove the HEPA exhaust filter.
3 Rinse the pleated side of the HEPA exhaust filter under a hot slow-
running tap as described in steps 3 and 5 of section 'HEPA dust
container filter and foam filter' above.
4 Place the dry HEPA exhaust filter back into the appliance.
5 To close the HEPA exhaust filter grille, first align the lugs on the top
of the grille with the slots in the appliance (1). Then press the tabs
downwards until the grille locks into place (2) ('click').

Cleaning the motor protection filter

To maintain optimal performance, clean the motor protection filter at least
once a year.
1 Lift the dust container out of the appliance by its handle.