Replacing Filters - Philips FC8149 Bedienungsanleitung

2 Pull the filter holder with the motor protection filter out of the
appliance.
3 Take the motor protection filter out of the holder. Shake the motor
protection filter over a dustbin to clean it.
4 Put the filter in the filter holder and slide the filter holder back into
the appliance.
5 Put the dust container back into the appliance.
replacement

replacing filters

Always unplug the appliance before you replace a filter.
Replace the HEPA filters every 12 months.
hEpa filters
- To remove the old filter and place the new filter, follow the instructions
for removing and placing the filters in section 'Cleaning the HEPA filters'
in chapter 'Cleaning'.
ordering filters and accessories
- HEPA exhaust filters are available under type number FC8070.
- Dust container filters (HEPA and foam) are available under type
number FC8071.
storage
1 Switch off the appliance and remove the mains plug from the wall
socket.
2 Press the cord rewind button to rewind the cord.
3 Put the appliance in upright position. To attach the nozzle to the
appliance, insert the ridge on the nozzle into the storage slot.
Note: To ensure stable storage of the telescopic tube, adjust the tube to the
shortest length.
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment.
English
15