Maintenance; Maintenance Schedule - McCulloch T26CS Bedienungsanweisung

WARNING: Do not touch the cover. It
can burn your skin and cause electrical
shock if the spark plug cap is damaged.
Do not use a product with damaged
spark plug cap.
To start a warm engine
1. Put the stop switch to the start position.
2. Push the air purge bulb 10 times.
3. Set the choke control to the run position, then pull
the start rope until the engine starts.
To stop the product
• Push the stop switch to stop the engine. (Fig. 29)
Note: The stop switch automatically goes back to its
initial position.
Grass trimming with a trimmer head
To clear
(Fig. 48)
To achieve the best results:
• Hold the trimmer so that the trimmer head is just
above the ground.
• Tilt the trimmer head at a slight angle.
• Let the end of the trimmer line strike the ground
around objects
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass. (Fig. 49)
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.

Maintenance schedule

Maintenance

Clean the external surface.
Clean the air filter. Replace if it is necessary.
Examine the function of the throttle trigger lock and the throttle.
Examine the stop switch.
Examine the guards.
12
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
(Fig. 48)
To cut the grass
1. Make sure that the trimmer line is parallel to the
ground when you cut the grass. (Fig. 50)
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed. (Fig. 51)
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
To replace trimmer line
Refer to the last page of this operator's manual.
Maintenance
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer line to
prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
Daily Weekly
X
X
X
X
X
Monthly
1190 - 001 -