Assembly; Operation - McCulloch T26CS Bedienungsanweisung

Introduction
WARNING: Before you assemble the
product, you must read and understand the
safety chapter.
WARNING: Remove the spark plug cable
from the spark plug before you assemble the
product.
To attach the loop handle
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten. (Fig. 33)
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling. (Fig. 34)
2. Align the tab of the cutting attachment (A) with the
hole on the coupling (B). (Fig. 35)
3. Carefully push the shaft into the coupling until you
hear a click. (Fig. 36)
4. Tighten the knob fully. (Fig. 34)
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling. (Fig. 34)
2. Push and hold the button (C).
3. Hold the end with the engine unit tightly.
4. Remove the cutting attachment from the coupling.
(Fig. 37)
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Fuel
This product has a two-stroke engine.
CAUTION: Incorrect type of fuel can result in
engine damage. Use a mixture of gasoline
and two-stroke oil.
10

Assembly

WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 16 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
To assemble the cutting attachment guard and
trimmer head
1. Assemble the cutting attachment guard. (Fig. 38)
2. Install the dust cup on the shaft. Make sure that the
dust cup covers the nut. (Fig. 39)
3. Hold the dust cup with a combination wrench to
prevent that the shaft rotates.
4. Assemble the trimmer head onto the shaft.
To disassemble the cutting attachment guard
and trimmer head
1. Stop the engine fully.
2. Hold the dust cup with an combination wrench to
prevent that the shaft rotates. (Fig. 40)
3. Turn the trimmer head counterclockwise until it is
loose.

Operation

Premixed fuel
• Use Husqvarna premixed alkylate fuel of a good
quality, for best performance and extension of the
engine life. This fuel contains less harmful chemicals
compared to regular fuel, which decreases harmful
exhaust fumes. The quantity of remains after
combustion is lower with this fuel, which keeps the
components of the engine more clean.
Accessories on
1190 - 001 -