McCulloch T26CS Bedienungsanweisung Seite 11

To mix fuel
Gasoline
• Use good quality unleaded gasoline with a maximum
of 10% ethanol contents.
CAUTION: Do not use gasoline with an
octane grade less than 90 RON/87 AKI.
Use of a lower octane grade can cause
engine knocking, which causes engine
damages.
• We recommend that you use gasoline of a higher
octane grade for work with continuously high rpm.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
(Fig. 41)
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
1190 - 001 -
To fill the fuel tank
1. Clean the area around the fuel tank cap. (Fig. 42)
2. Shake the container and make sure that the fuel is
3. Remove the fuel tank cap and fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m/10 ft or more away from the
Note: To see where the fuel tank is on your product,
refer to
To examine before start
1. Make sure that the product has no missing,
2. Make sure that nuts, screws and bolts are tightened.
3. Make sure that the trimmer head is not damaged.
4. Make sure that the air filter is not clogged.
5. Make sure that the safety devices on the product are
6. Make sure that the product has no fuel leaks.
Two-stroke oil,
To start a cold engine
liter
1. Put the product on a flat surface and make sure that
2% (50:1)
0.10
2. Squeeze throttle trigger in full position. (Fig. 43)
0.20
3. Push the air purge bulb 10 times. (Fig. 44)
4. Move the choke control to the choke position. (Fig.
0.30
0.40
5. Hold the product to the ground. Pull the starter rope
6. Move the choke control to the run position and pull
7. Push the throttle trigger lightly and run at low speed
CAUTION: Do not mix fuel for more than 1
month at a time.
fully mixed.
refueling area and fuel source before you start the
engine.
Product overview on page 5 .
damaged, loose or worn parts.
not defective.
no objects touch the cutting attachment.
45)
handle slowly with your right hand until you feel
resistance. Pull the starter rope handle quickly and
with force until you hear the engine start. (Fig. 46)
Note: Do not twist the starter rope around your hand.
(Fig. 47)
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle. That can cause
damage to the product.
the starter rope handle until the engine starts.
for 60 seconds.
11