Waste Disposal; Ordering Replacement Parts; Cleaning And Maintenance - EINHELL Royal RT 3525 Gebrauchsanweisung

Anleitung RT 3525 SPK1 19.09.2006
To cut properly, swing the machine sideways
while moving forwards. Keep the grass trimmer
inclined at an angle of approx. 30° while you do
so (see Figs. 10 and 11).
If the grass is long, the grass must be cut shorter
in stages, starting from the tip (see Fig. 12).
Use the edge guide and the guard hood to
prevent unnecessary wear on the line.
To avoid unnecessary wear on the line, keep the
grass trimmer away from hard objects.
8. Replacing the line spool
IMPORTANT! Make sure that you pull out the
power plug before exchanging the line spool!
Press the sides of the spool cover (A) as shown
and remove it with the spool (B / Figure 7). Make
sure that you do not lose the spring.
Thread the ends of the line on the new spool
through the eyelets in the spool receptacle (Fig.
8).
Fit the spool cover and spool back into the spool
mounting (Fig. 9).
Press the pushbutton and pull the line out to the
edge of the guard hood.
The line will be cut to the correct length when the
cutting head starts up again.
Important. Bits of the nylon line could cause
injury when being flung out.

9. Cleaning and maintenance

Switch off and unplug the grass trimmer before
putting it away or cleaning it.
Remove deposits from the guard hood with a
brush.
Clean the plastic body and plastic parts with a
mild household detergent and a damp cloth.
Never use aggressive agents or solvents for
cleaning purposes!
Never spray down the grass trimmer with water.
Prevent water getting into the trimmer at all cost.
10. Faults
The machine does not work: Check that the
power cable is connected properly and check the
mains fuses. If the machine will not work in spite
of the voltage supply being OK, please send it to
the specified after-sales service address.
15:23 Uhr Seite 13

11. Waste disposal

Please note
The grass trimmer and its accessories are made
of various types of material such as metal and
plastic.
Defective components must be disposed of as
special waste.
Ask your dealer or your local council.

12. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part
required
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. No.: 34.050.45
GB
13