EINHELL Royal RT 3525 Gebrauchsanweisung Seite 11

Anleitung RT 3525 SPK1 19.09.2006
Make sure that the air vents are free of dirt.
Disconnect the machine from the mains after use
and check the machine for damage.
Do not try to use the machine to cut grass which
is not growing on the ground; for example, do not
try to cut grass growing on walls or stones, etc.
The person operating the grass trimmer is liable
for any damages sustained by third parties within
the machine's working radius as a result of its
use.
Do not cross roads or gravel paths with the
machine switched on.
When you are not using the machine, keep it in a
dry place out of the reach of children.
Use the machine only in the way described in
these operating instructions and always hold it
perpendicular to the ground. Every other position
is dangerous.
Check at regular intervals that the screws are
properly tightened.
The mains supply must be the same as the
voltage indicated on the rating plate.
The power cable must be examined regularly for
signs of damage or ageing. Do not use the
machine if the power cable is in a less than
perfect condition.
The power cables used are not to be of a lighter
duty class than light rubber-insulated HO7RN-F
in accordance with DIN 57282/VDE 0282 and
they must have a minimum diameter of 1.5 mm
Plug connections must have earthing contacts
and the coupling must be protected from
rainwater.
If the cable is damaged during operation,
disconnect it immediately from the power supply.
DO NOT TOUCH THE CABLE BEFORE IT IS
DISCONNECTED FROM THE POWER
SUPPLY.
To prevent danger, damaged power cables must
be replaced by the manufacturer or a service
company authorized by the manufacturer.
The machine may only be powered via an earth-
leakage circuit breaker (RCD) with a maximum
operating current of 30 mA.
The area to be cut must always be kept cleared
of cables and other objects.
If the machine has to be lifted for transporting, be
sure to switch off the motor first and wait for the
cutter to come to a standstill. Each time before
you leave the machine, switch off the motor and
pull out the power plug.
Before you connect the machine to the power
supply, make sure that none of the rotating
components is damaged and that the line reel is
properly inserted and secured
15:23 Uhr Seite 11
Under no circumstances are you to cut against
hard objects during use. This is imperative to
prevent injury to yourself and damage to the
machine.
Use only original replacement parts for repairs.
Repairs may only be carried out by a qualified
electrician.
Before starting up the machine, and after any
collision, check the machine for signs of wear or
damage and have any necessary repairs carried
out.
Always keep your hands and feet away from the
cutting unit, especially when switching the motor
on.
After you pull out a new line, always turn the
machine to its normal working position before
switching on.
Never use spare parts and accessories which
are not provided or recommended by the
manufacturer.
Pull out the mains plug before checking, cleaning
or doing any work on the machine and when it is
not being used.
Use the machine only in broad daylight or in well-
lit conditions.
Please note: The nylon line continues to
rotate for a few seconds after the motor is
switched off.
2 .
2. Layout (see Fig. 1)
1. Power cable
2. Cable strain-relief clamp
3. ON/OFF switch
4. Upper Handle
5. Front grip
6. Line spool
7. Guard hood
GB
11