DeWalt DCF825 Übersetzt Von Den Originalanweisungen Seite 38

EN GLI SH
WARNING: To reduce the risk
of serious personal injury, place
the forward/reverse button in
the lock-off position or turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories.
Proper Hand Position (fi g. 1, 3)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the main
handle (k).
Variable Speed Trigger Switch (fi g. 1)
To turn the tool on, squeeze the trigger switch (a). To
turn the tool off, release the trigger switch. Your tool
is equipped with a brake. The tool will stop when the
trigger switch is fully released.
The variable speed switch enables you to start
the application at a slow speed. The further you
squeeze the trigger, the faster the tool will operate.
For maximum tool life, use variable speed only for
starting holes or fasteners.
NOTE: Continuous use in variable speed range is
not recommended. It may damage the switch and
should be avoided.
Forward/Reverse Control Button
(fi g. 1)
A forward/reverse control button (b) determines the
direction of the tool and also serves as a lock-off
button.
To select forward rotation, release the trigger switch
and depress the forward/reverse control button on
the right side of the tool.
To select reverse, release the trigger switch (a) and
depress the forward/reverse control button on the
left side of the tool. The center position of the control
button locks the trigger switch (a) in the off position.
When changing the position of the control button,
be sure the trigger is released.
NOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up.
This is normal and does not indicate a problem.
36
Worklights (fi g. 1)
There are three worklights (g) located around the
6.35 mm (1/4") hex chuck (d). The worklights are
activated when the trigger switch is depressed.
When the trigger is released, the worklight will stay
illuminated for up to 20 seconds.
NOTE: The worklights are for lighting the immediate
work surface and are not intended to be used as a
flashlight.
Speed Selector (fi g. 1, 4)
Your tool is equipped with a speed selector (j) which
allows you to select one of three speeds. Select
the speed based on the application and control the
speed of the tool using the variable speed trigger
switch (a).
DCF825
Speed 1 rpm 0–900
Speed 2 rpm 0–1850
Speed 3 rpm 0–2800
Accessory Insertion and Release
(fi g. 1, 5, 6)
NOTE: These tools only accept 6.35 mm (1/4") hex
accessories.
To install an accessory, fully insert the accessory into
the chuck (d). The accessory is locked into place
(fig. 5).
To remove an accessory, push on the accessory
release button (c). Remove the accessory then
release the accessory release button (fig. 6).
Usage
Your impact tool generates the following maximum
torque:
Cat #
DCF825
DCF895
CAUTION: Ensure fastener and/or
system will withstand the level of torque
generated by the tool. Excessive torque
may cause breakage and possible
personal injury.
1. Place the socket on the fastener head. Keep
the tool pointed straight at the fastener.
2. Press switch to start operation. Release the
switch to stop operation. Always check torque
with a torque wrench, as the fastening torque is
affected by many factors including the following:
DECF895
0–950
0–1900
0–2850
Nm
160
170