Manufacturer's Introduction; General Istructions; Trasport, Stocking, Unpacking; Product Description - CMO HPB Gebrauchs- Und Wartungsanleitung

1. MANUFACTURER'S INTRODUCTION

The hydro pneumatic pump, that you are going to use, is a product guaranteed by the used
technology, by the quality of employed materials and by the constructive techniques based on the
high professionalism of business personnel.
The pump is the only one, of its kind, entirely built in aluminium and brass, with mechanical
details exclusively made on the numerically controlled work centre. It guarantees the product
uniformity.
Every pump is tested and is guaranteed for 12 months.
A constant applied search, has allowed to introduce in the market the exclusive pump with
remote control.
This model is very appreciated from end-users thanks to its convenience and safety
pump with RC (Remote Control) boasts illustrious attempts of imitation by competition.
Produces, with special patent, hydro pneumatic pumps operated with Radio control too, this
allows, to manage up to three hydro pneumatic unities with a pocket Remote control.
Apply the following easy instructions and our PUMP will be to your service for many years.
Good work and thank-you to have chosen.
2. GENERAL INSTRUCTIONS
Before install and use the pump read carefully this handbook and follow the simple instructions.
The manual will have to follow the pump and the machinery on which it will be assembled, also
in case of transfer of the same one. Builder supplies hydro pneumatic pump with EC certificate.
It's forbidden to end users its put in operating before that the machinery in which will be
incorporated or assembled has not been declared conforming with rules, EC 89/392, 91/368,
93/44, 93/68 as well as to the following laws. EC declaration is up to builder of end product.
Before put in operating the pump verify that has not had damages or oil losses during transport In
case of visible damages or oil losses, notify to transporter how much found, not install the pump
and contact the builder for information and instructions. The builder declines every responsibility
for no observance of what has been written in this handbook.
3. TRANSPORT, STOCKING AND DISINPACKING
The pump's packing must not be turned upside-down for avoiding the defusing of the same one.
The stocking, when the use has made many time after the purchase, must be done in rooms
adequately protected from atmospheric agents and with temperatures between +10° and 40°
centigrade. It is suggested to stack the boxes until a maximum of n. 3 pumps. The empty packing
must be destroyed according the laws in force.

4. PRODUCT DESCRIPTION

The PUMP is a multiple of pressure with a variable setting, it can be set only by builder in
testing phase it allows to obtain a hydraulic capacity from a pneumatic feeding. It can feed a
hydraulic device with single effect. Every other use of pump is unsuited. The pump is used for
car-lift in the garage, in the body shop, in the naval and mechanical industry always in
connection with hydraulic devices and rams.
Manufacturer declines every responsibility for damages caused by a no correct use of the
pump.
12