HELIX P ONE Bedienungsanleitung Seite 14

Connectors and control units
P ONE side view with optionally available HELIX Digital Input Module HDM 1
Status LED
1
This LED indicates the operating mode of the
amplifier.
Line Input
2
RCA inputs for connecting lowlevel line
signals.
Clipping LED
3
This LED lights up red if one of the inputs is
overdriven.
Gain
4
Control for adjusting the input sensitivity of
the lowlevel Line Inputs and the optional op-
tical input.
Input Mode
5
Switch to adapt the amplifier to the number of
used input channels.
Output Channel
10
Speaker outputs for connecting loudspeakers.
GND
11
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle).
14
1 2 3 5
4
10
6 7 8
optional
9
TwinPower Link switch
6
Switch for operating two P ONE amplifiers in
bridge mode.
TwinPower signal link
7
Signal in- and output for bridge mode opera-
tion in TwinPower Link mode.
SPDIF Direct In switch (optional)
8
Switch for routing the digital input signal
directly to the amplifiers internal power stage.
Optical Input (optional)
9
Optical input for digital stereo signals ( SPDIF
format).
11 12 13
REM
12
Connector for the remote cable.
+12 V
13
Connector for the +12 V power cable of the
positive terminal of the battery.