HELIX P ONE Bedienungsanleitung Seite 18

Installation
7. Connecting the remote input
The remote input (REM) has to be connected to
the radio remote output. This is only activated
if the head unit / car radio is switched on. Thus
the amplifier is switched on and off together with
the head unit / car radio.
We do not recommend controlling the remote
input via the ignition switch to avoid pop noise
during turn on / off.
If an additional digital signal processor (DSP)
is installed in the signal path between the radio
and the amplifier, the remote output of the DSP
must be used to turn on the P ONE.
Unique Features of the HELIX P ONE
Start-Stop capability
The switched power supply of the HELIX P ONE as-
sures operation even if the battery's voltage drops
down to 6 Volts during engine crank.
18
8. Connecting the loudspeaker outputs
The loudspeaker outputs can be connected
directly to the wires of the loudspeakers. Never
connect any of the loudspeaker cables to the
chassis ground as this will damage your ampli-
fier and your speakers.
The positive terminal is indicated on most
speakers. The impedance must not be less
than 1 Ohm (2 Ohms in TwinPower Link mode),
otherwise the amplifier protection will be acti-
vated. Examples for speaker configurations can
be found on page 19 et sqq.
High-Resolution audio
The extremely broadband audio bandwidth of the
amplifier ensures a lossless audio reproduction of
High-Resolution audio content to provide the best
possible sound in studio quality.