Teaching In The Actuator; Installation - Pilz PSEN cs2.13p ATEX Bedienungsanleitung

PSEN cs2.13p ATEX
Legend:
I0
I1
I2

Teaching in the actuator

Teaching in the actuator for the first time:
The first actuator PSEN cs2.1 detected by the safety switch is automatically taught in as
soon as it is brought into the response range.
To teach in a new actuator:
A maximum of 8 learning procedures are possible.
}
1. The actuator that is to be taught in must be brought into the safety switch's response
range as the only transponder. As soon as the actuator is detected, the "Safety Gate"
LED will flash yellow.
2. After 20 s has elapsed, the "Safety Gate" LED turns to quick yellow flashes. Trigger a
system reset in the next 120 s by interrupting the power supply.
3. When the supply voltage is switched back on, the learning procedure is complete and
the number of permitted additional learning procedures is reduced by 1.

Installation

The safety switch and actuator should be installed opposite each other in parallel.
}
Safety switches and actuators should be permanently secured using M5 safety screws
}
with a flat head (e.g. M5 cheese-head or pan head screws).
Protect the actuator from contamination.
}
Torque setting: Please note the information provided under
}
The distance between two safety switches must be maintained (see
}
details [
Make sure that the safety switch and actuator cannot be used as an end stop.
}
Operating Manual PSEN cs2.13p ATEX
21133-2EN-1
Input OSSD
Input OSSD
Signal input
NOTICE
– The actuator must not be removed during the learning procedure.
– This actuator cannot be retaught on the same safety switch.
CAUTION!
The unit's properties may be affected if installed in an environment contain-
ing electrically or magnetically conductive material. Please check the oper-
ating distances and the assured release distance.
43]).
Technical details [ 43].
Technical
39