Instructions For Use; Maintenance; Winter Preparation - Swim & Fun 1401 Handbuch

8.

Maintenance

• Regularly check the water flow to the heat pump. A water flow that is too low and the ingress of
air into the system should be avoided, as this will reduce the performance and reliability. You
should clean the pool/spa filter regularly to avoid damage caused by dirty or clogged filters.
• The area around the heat pump should be dry, clean and well ventilated. Clean the sides of the
heat exchanger regularly to maintain a good thermal exchange and save energy.
• Regularly check the power supply and connecting cable. If the unit starts to function abnormally
or any of the electrical components smell unusual, immediately turn off the heat pump and have
the relevant components replaced.
• You must disconnect the water flow to the heat pump, if the heat pump will not be in operation
for a long period of time. Always check all parts of the unit and installation carefully before start-
ing it up again. Please also read section 8. Winter preparation.
9.

Winter preparation

It is important that you disconnect the water flow to the heat pump in winter, when the heat pump is
not in operation, or when the ambient temperature drops below -12°c.
Water in the system, which freezes to ice, will damage the titanium heat exchanger. If this happens,
your warranty will be void.
We also recommend that the heat pump is covered during the winter.
If it is possible to keep the heat pump indoors during winter, then this will contribute to a long prod-
uct life.
10. Warranty
Limited warranty
We guarantee that all parts are free of defects in materials and workmanship for a period of two
years from the date of purchase. A 7 year warranty is given for the compressor. The warranty cov-
ers only material or manufacturing defects that prevent the product from being able to be installed
or operated in a normal way. Defective parts will be replaced or repaired.
The warranty does not cover transportation damage, any use other than what is intended, damage
caused by incorrect assembly or improper use, damage caused by impact or other error, damage
caused by frost cracking or by improper storage.
The warranty becomes void if the user modifies the product.
The warranty does not include product-related damage, property damage or general operational loss.
The warranty is limited to the initial retail purchase and cannot be transferred and it does not apply
to products moved from their original location.
The manufacturer's liability cannot exceed the repair or replacement of defective parts and does
not include labour costs to remove and reinstall the defective part, transportation costs to and from
the service centre, and all other materials necessary to carry out the repair.
140
MV-1401-1402-1403-01-2020 . © All rights reserved Swim & Fun Scandinavia ApS
UK