Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Warnings And Notices; Installation Guide - Swim & Fun 1401 Handbuch

Vorschau ausblenden Andere Handbücher für 1401:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 153
UK
3.

Safety warnings and notices

• The main power switch should be installed out of the reach of children to avoid the danger
caused by them playing with the switch.
• Make sure that the power cable is removed from the power supply, if it is necessary to remove
the cover of the machine during repair and maintenance.
• The installer must read the manual and pay attention to its instructions during the commissioning
and when performing maintenance:
• The installer is responsible for the installation of the product and must follow all of the
manufacturer's connection instructions as well as adhering to all legislation. Incorrect installation
compared with the manual voids the entire product warranty.
• The manufacturer disclaims any liability for damage to persons and objects resulting from
a faulty installation in relation to the manual's guidelines. Any use that is not in accordance
with the manufacturer's instructions is considered dangerous.
• ALWAYS remove water and hoses from the heat pump during the winter, when the heat pump
is not in operation, or when the ambient temperature drops below -12°C. Otherwise, the heat
exchanger may be damaged by frost. In such a case your warranty will be void. Please also
read section 8. Winter preparation.
• Always isolate the power supply if you want to open the cabinet to reach inside the
heat pump. There is a strong current inside.
• You should check the water supply on a regular basis to avoid reduced water flow and
to avoid air getting into the system. The heat pump will not work when the water flow
is too low and air in the system can reduce the performance and reliability of the heat pump.
• The display/control unit must be kept dry. Therefore ensure that the lid is completely closed in
order to protect it from moisture damage.
• Clean both your pool and filter system on a regular basis in order to avoid damage to
heat pump due to a dirty or clogged filter.
• You must empty the water from the bottom of the pool's circulation pump, if the heat pump will
unused for a longer period of time, especially during the winter season.
4.

Installation guide

The heat pump must only be installed by qualified technicians. Incorrect installation will cause dam-
age to the unit and may result in physical injury or death for the users.
The device must be installed outdoors in a place with good ventilation. Any recycling of the heat
pump's cold discharge air as intake air for the heat pump will noticeably reduce the efficiency and
the heat pump will no longer be covered by the product warranty.
The unit can be installed almost anywhere outdoors.
MV-1401-1402-1403-01-2020 . © All rights reserved Swim & Fun Scandinavia ApS
127

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

14021403

Inhaltsverzeichnis