Swim & Fun 1401 Handbuch Seite 138

Parameter setting
Select the parameter setting menu A and press the settings button B to enter the menu. Press C or
D button to choose values between P0 and P17 and press the setting button B to set the value.
Note
Press the settings button for 15 seconds to set P14 and P17
Usage of parameters P0 to P17
Code Name
P0 Mandatory defrosting
P3 Water pump
P7 Water temp. calibration
P14 Restore to factory settings 0-1
P17 WiFi/MODBUS
How parameter P3=0 works - depends on the operation of the compressor.
When the heat pump turns on, the water pump will start, then the fan and at last the compressor.
Heating mode
Cooling mode
138
A B
Area of application
0-1
0-1
-9~9
0-1
Condition
T1≥Tset-0.5°C, last for 30
minutes
T1°C Tset+0.5°C, last for
30 minutes
1 hour later
MV-1401-1402-1403-01-2020 . © All rights reserved Swim & Fun Scandinavia ApS
C D
Default Remark
0 0: Default normal operation
1: mandatory defrosting
0 1: Always running;
0: Depends on the operation of the com-
pressor
0 Default setting: 0
0 1-Restore to factory settings, 0- default
(restore P0, P3, P7, P8, P9,P10, P11 to
factory setting)
0 1—WiFi, 0—MODBUS
Example Tset=28°C Water pump
T1≥27.5°C, last for Water pump will enter standby
30 minutes mode for 1 hour and will not start
except after manual power off and
T1°C 28.5°C, last for
restart. Compressor and fan motor
30 minutes
stops first and water pump will stop
after 5 minutes.
UK