General; Safety Instructions - Swim & Fun 1058 Bedienungsanleitung

UK
1.

General

1.1

Safety instructions

WARNING:
Please read carefully the safety instructions before using the equipment.
The following instructions are essential for safety so please strictly comply
with them.
During installation and servicing
Only a qualified person may undertake installation, start-up, servicing and
repairs, in compliance with current standards.
Before operating or undertaking any work on the equipment (installation,
commissioning, usage, servicing), the person responsible must be aware of all
the instructions in the heat pump's installation manual as well as the technical
specifications.
Under no circumstances install the equipment close to a source of heat,
combustible materials or a building's air intake.
If installation is not in a location with restricted access, a heat pump protective
grille must be fitted.
To avoid severe burns, do not walk on pipework during installation, repairs or
maintenance.
To avoid severe burns, prior to any work on the refrigerant system, turn off the
heat pump and wait several minutes before placing temperature and pressure
sensors.
Check the refrigerant level when servicing the heat pump.
Check that the high and low pressure switches are correctly connected to the
refrigerant system and that they turn off the electrical circuit if tripped during
the equipment's annual leakage inspection.
During use
To avoid serious injuries, never touch the fan when it is operating.
Keep the heat pump out of the reach of children to avoid serious injuries caused
by the heat exchanger's blades.
MV-1058-1059-10-2021 . swim-fun.com © All rights reserved Swim & Fun A/S
110