Troubleshooting; Possible Cause; Spare Parts List - Modster Arrows Hobby F8F Handbuch

Troubleshooting

Problem
Aircraft will not respond to
the throttle but responds to
other controls.
Excessive vibration or
propeller noise.
Reduced flight time or
aircraft underpowered.
Control surfaces
unresponsive or sluggish.
Controls reversed.
Motor loses power
Motor power pulses then
motor loses power.
LED on receiver flashes
slowly.

Spare parts list

AHAD101 Fuselage
Main wing set
AHAD102
Horizontal stabilizer
AHAD103
Cockpit
AHAD104
Auxiliary fuel tank
AHAD105
Spinner
AHAD106
Main landing gear set
AHAD107
Rear landing gear set
AHAD108
Main landing gear system
AHAD109
AHAD110 Linkage Rods
Horizontal stabilizer spar
AHAD111
Screw set
AHAD112
AHAD113 Decal sheet
AHAD114 Machine gun
AHRE002 E-retract
Propeller
AHPROP004

Possible Cause

ESC is not armed.
Throttle channel is reversed.
Damaged spinner, propeller,
motor or motor mount.
Loose propeller and spinner parts.
Propellor installed backwards.
Flight battery charge is low.
Propeller installed backward.
Flight battery damaged.
Control surface, control horn,
linkage or servo damage.
Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
Damage to motor, or battery.
Loss of power to aircraft.
ESC uses default soft Low Voltage
Cutoff(LVC).
Power loss to receiver.
Solution
Lower throttle stick and throttle trim to lowest
settings.
Reverse throttle channel on transmitter.
Replace damaged parts.
Tighten parts for propeller adapter, propeller
and spinner.
Remove and install propeller correctly.
Completely recharge flight battery.
Replace flight battery and follow flight battery
instructions.
Replace or repair damaged parts and adjust
controls.
Do a check of connections for loose wiring.
Do the control direction test and adjust controls for
aircraft and transmitter.
Do a check of batteries, transmitter, receiver, ESC,
motor and wiring for damage(replace as needed).
Land aircraft immediately and recharge flight battery.
Check connection from ESC to receiver.
Check servos for damage.
Check linkages for binding.
AHMount001 Motor mount
Motor shaft
AHShaft001
Motor board
AHBoard002
3536-KV850 Motor
AHKV850
AHESC40A 40A ESC(200mm input cable)
AHSER9GP 9g servo positive
10