Connecting Analyzer To Power Supply - Stihl MDG 1 Gebrauchsanleitung

Connecting Analyzer to
Power Supply
Wall outlet
Mains voltage and the operating voltage
of the power supply unit must be the
same.
1
2
Select the mains plug adapter that
N
suits the wall outlet.
Slide the adapter into the power
N
supply unit's slot (1) – the adapter
must snap into position.
To remove the adapter:
Depress the latch (2) and pull out
N
the adapter.
MDG 1
2
Connect cord (1) to analyzer'
N
socket and the power supply unit's
receptacle (2) – note coding of
connections.
Tighten down the connections.
N
Insert the power supply unit in a wall
N
outlet.
STIHL AAD 1 analyzer battery adapter
B
Connect cord (1) to MDG 1 plug (B)
N
and AAD 1 socket (2) and tighten
down the connections
Self test
A self test is performed after the
analyzer is connected to the power
supply.
1
A
During this process the LED (1) on the
analyzer glows green, then yellow, then
red and then continuously green – end of
self test.
LED (1) glows continuously red: internal
malfunction – replace the analyzer.
LED (1) flashes green. Supply voltage
too low. Ensure correct supply voltage
and restart analyzer. The analyzer must
be reintroduced to SDS.
LED (2) flashes white: Analyzer ready
for operation – no connection to
computer – check connection.
1
2
English
2
B
0/
1
17