Diagnostic Testing; Storing; Preparing The Analyzer; Connecting Analyzer To Power Supply - Stihl ADG 2 Gebrauchsanleitung

5 Preparing the Analyzer

► Never insert objects in the analyzer's openings.
► Never bridge an analyzer's contacts with metallic
objects (short circuit).
► Do not open the analyzer.
► If you have any queries: Contact your STIHL servicing
dealer for assistance.
4.6

Diagnostic Testing

Contact with live components may occur for the following
reasons:
– Connecting cable is damaged.
– Plug is damaged.
– Wall outlet is not properly installed.
WARNING
￭ Contact with live components can result in an electric
shock. This may result in serious or fatal injuries.
► Check that the connecting cable and plug are not
damaged.
► Insert the plug in a properly installed wall outlet.
￭ Overvoltage can occur in the analyzer if the line voltage or
frequency are incorrect during diagnostic testing. The
analyzer may be damaged.
► Make sure the line voltage and frequency agree with the
data on the analyzer's rating label.
￭ A damaged or defective analyzer may produce an unusual
smell or emit smoke during diagnostic testing. This may
result in personal injuries and damage to property.
► Disconnect the plug from the wall outlet.
￭ The analyzer can overheat and cause a fire if heat
dissipation is inadequate. This can result in serious or
fatal injuries and damage to property.
► Do not cover the analyzer.
0458-757-9921-B
4.7

Storing

WARNING
￭ Children are not aware of and cannot assess the dangers
of an analyzer. Children may sustain serious or fatal
injuries.
► Store the analyzer out of the reach of children.
￭ The analyzer is not protected against all ambient
conditions. The analyzer may be damaged if it is exposed
to certain ambient conditions.
► If the analyzer is hot: Allow analyzer to cool down.
► Store the analyzer in a clean and dry condition.
► Store the analyzer in a closed location.
￭ The connecting cable must not be used for carrying or
hanging up the analyzer. The connecting cable and the
analyzer may be damaged.
► Hold the analyzer by the housing.
5 Preparing the Analyzer
5.1

Connecting Analyzer to Power Supply

1
2
► Insert the plug (4) in a convenient wall outlet (5).
The analyzer (1) runs a self test. The LED (2) glows green
for about 1 second and then red for about 1 second.
► Lay the connecting cable (3).
English
4
3
5
15